2 Replies Latest reply on Oct 7, 2015 2:21 AM by dfortier

    ISR 9024D-M reset admin pwd / factory reset

    dfortier

      Hello,

           New to Infiniband and hoping someone can point me in the right direction. I picked up an ISR 9024D-M for my home lab (studying for certs VMware mostly), and the seller didn't reset the password. From reading a number of posts here I have been able to locate and test the defaults for "manager" (Grid vision) and root for CLI. I tried hold the reset for 30  secs, but that didn't work. Have I over looked something obvious? Should i be looking for a firmware update to reset it?

       

      Also, can the fan unit be safely removed? I seem to recall reading somewhere when i was comparing, that it can if you aren't running all 24 ports?

       

      Thanks for your time

        • Re: ISR 9024D-M reset admin pwd / factory reset
          eddie.notz

          Hi Dan,

           

          If admin/123456 didn't work try the below procedure (will require console access):

           

          While unit is booting you should hit ctrl-c and when prompted for login

           

           

          user : admin

          password : 123456

           

           

          you should get prompt

           

           

          Safe mode%

           

           

          in here (as shown below from my unit) is an option to restore default.

           

           

           

           

          0 login: admin

          Password:

          Safe mode%

          Safe mode%?

          Command Description

          ----------------------------------------------------------------

          ip-address - set/show ip address

          default-geteway - set default geteway

          show-ip - show ip

          route-show - show route table

          ping - ping

          telnet - telnet

           

           

          update-software - get new software version by FTP

           

           

          factory-default - use factory default configuration

          set-config-old - use old configuration

           

           

          import - import configuration by FTP

           

           

          reload - reload the nVigor

           

           

          ? - help

           

           

          Safe mode%