1 Reply Latest reply on Dec 18, 2014 7:32 AM by kevinschmidt

    4036E software update

      Hello,

       

      I have a 4036E switch and I am trying to update the software.  Here is the system info:

      4036E.png

      The health monitor shows:

      4036E-2.png

      The update software chassis gives:

      4036E-3.png

      with each .fpf being identical to the one on the flash.  The programing finishes successfully and reboots:

      4036E-4.png

      during the load everything looks the same as other switches except:

      4036E-5.png

      But when it finishes loading it is right back where it started:

      4036E-6.png

       

      Any ideas about what is going on here?

       

      Thank you,

       

      Kevin

        • Re: 4036E software update

          After some more searching I found the solution to this issue is to update the software to version 3.62 and then to 3.91-987.  In my case I was able to skip the other versions in between.  I had to contact Mellanox support to get the correct software and firmware versions for the 4036E.

           

          I hope this helps someone out there.

           

          Kevin

          1 of 1 people found this helpful