2 Replies Latest reply on Nov 7, 2014 5:42 AM by rickp

    Firmware upgrade for ConnectX-2

      Hello,
      in three computers I have three dual port 10 Gb NICs ConnectX-2. I would like to upgrade their firmwares. I followed instruction how to identify correct adapter on: http://www.mellanox.com/page/firmware_HCA_FW_identification

      I got these results:

       

      C:\Program Files\Mellanox\WinMFT>mst status
      MST devices:
      ------------
        mt26448_pci_cr0
        mt26448_pciconf0

      C:\Program Files\Mellanox\WinMFT>flint -d /dev/mst/mt26448_pci_cr0 query
      Image type:      FS2
      FW Version:      2.7.8200
      Rom Info:        type=PXE version=1.5.6 devid=26448 proto=ETH
      Device ID:       26448
      Description:     Port1            Port2
      VSD:
      PSID:            IBM0DB0000010

      C:\Program Files\Mellanox\WinMFT>flint -d /dev/mst/mt26448_pciconf0 query
      Image type:      FS2
      FW Version:      2.7.8200
      Rom Info:        type=PXE version=1.5.6 devid=26448 proto=ETH
      Device ID:       26448
      Description:     Port1            Port2
      VSD:
      PSID:            IBM0DB0000010

       

      The problem is that PSID is not in the format "MT_".
      I checked a list of firmwares on http://www.mellanox.com/page/firmware_table_ConnectX2EN and I am not sure what is the correct.
      Can anyone give me advice please?

       

      I suppose I have MNPH29C-XTR because I found photo of a card on eBay (looks same as my card) and the card is described as MNPH29C-XTR.

       

      And the second question please:
      When I type "mst status" then I got two devices. Should I run update for both of them?

       

      flint -d <First device> -I <binary image> burn
      flint -d <Second device> -I <binary image> burn

       

      Thank you.

       

      Rick Penic