2 Replies Latest reply on Aug 10, 2014 9:12 AM by anoopcs9

    Need help on installing Mellanox OFED on RHEL 6.4

      Hi all,

       

      Recently I downloaded the Mellanox OFED [ MLNX_OFED_LINUX-2.2-1.0.1-rhel6.4-x86_64.tgz ] and tried to install using mlnxofedinstall script on my rhel system with kernel 2.6.32-358.46.2.el6.x86_64. The installation was succesful and firmware was upto date. After restarting /etc/init.d/openibd I ran hca_self_test.ofed which resulted in the following output.

       

      ---- Performing Adapter Device Self Test ----

      Number of CAs Detected ................. 1

      PCI Device Check ....................... PASS

      /usr/bin/hca_self_test.ofed: line 165: [: too many arguments

      Host Driver RPM Check .................. FAIL

          REASON: no RPMs found for currently booted kernel 2.6.32-358.46.2.el6.x86_64

      Kernel Arch ............................ x86_64

      Host Driver Version .................... NA

      Firmware Check on CA #0 (VPI) .......... NA

      Host Driver Initialization ............. NA

      Number of CA Ports Active .............. NA

      Error Counter Check .................... NA

      Kernel Syslog Check .................... NA

      Node GUID on CA #0 (VPI) ............... f4:52:14:03:00:2a:bd:70

      ------------------ DONE ---------------------

       

      The result was same after rebooting the system. On running sestatus

       

      SELinux status:                 enabled

      SELinuxfs mount:                /selinux

      Current mode:                   permissive

      Mode from config file:          permissive

      Policy version:                 24

      Policy from config file:        targeted

       

      And ifconfig didn't show up the ib interface. Is there anything that I have missed to configure before/after installation of Mellanox OFED?