This document will explain how to deploy EVPN Symmetric routing as the overlay technology on top of a leaf/spine network, we will be using Cumulus OS running on top of a Mellanox Spectrum switch. Topology: Let’s start with the basics, the requirement is to build a data center environment with the building blocks of
VMware vSphere 6.5/6.7 How To Install Mellanox Firmware Tools (MFT) on VMware ESXi 6.5/6.7 How To manage port type in Mellanox ConnectX®-4/ConnectX®-4 Lx/ConnectX®-5 Adapters for VMware ESXi 6.x How To Install/Upgrade Mellanox NATIVE ESXi Driver for VMware vSphere ESXi 6.5/6.7 host How To Configure SR-IOV for Mellanox
Hi, I have a problem with local invalid/send with invalid operation with ConnectX-4 NICs. [863318.002031] mlx5_0:dump_cqe:275:(pid 31419): dump error cqe [863318.002032] 00000000 00000000 00000000 00000000 [863318.002033] 00000000 00000000 00000000 00000000 [863318.002034] 00000000 00000000 00000000 00000000 [863318.002035]
Hi, I'm looking for information how to implement vRouter hardware offload with ConnectX-5 EN especially with OpenContrail? I find on http://www.mellanox.com/related-docs/prod_adapter_cards/PB_ConnectX-5_EN_Card.pdf that offload is supported. Best regards,
This post discusses Mellanox NEO - Cloud Networking Orchestration and Management. This post is basic and meant for IT managers. Table of Contents
Table of Contents
References
What is Mellanox NEO?
Dashboard
Main Interfaces
Centralized Switch Management
Provisioning
Health Monitoring
Auto-Discovery
This post describes how to enable the SDN Mechanism Driver of OpenStack to allow Neutron notification of port or network updates. It is meant for developers or advanced OpenStack users. References OpenStack wiki page Mellanox-Neutron-ML2 Driver Configuration Mellanox NEO product page Overview The SDN Mechanism Driver is used to
Hello, i have two SX6018 switches: one boots just fine, second one stops in a different mode: Switch-B(4)> and MLNX-OS commands are not available. Could anyone help me to figure out what is wrong? How to boot into normal MLNX-OS mode? Thank you in advance! Here are the logs from good and bad switches: GOOD
